2.0 TDI EA189 Biturbo VW T5.2 oil cooler-kit BAR-TEK®

Complete, high-quality oil cooler kit for the VW T5.2 Biturbo Bus.This kit not only impresses with its simple installation, but also has a constant oil temperature and oil pressure control due to its high level of workmanship. The advantages for your VW T5: Engine seals do not harden The service life of the engine is positively influenced Particularly suitable in warm climates or when towing a trailer. 33-piece complete kit: 13 rows oil cooler Setrab Flange with thermostat (opens to approx. 90 °C) Special flange adapter Complete sealing and mounting material Two custom-fit oil cooler holders 13-row oil cooler: Length 405 mm Net width 295 mm Height 100 mm M22x1.5 thread We recommend using our special TDI oil! ATTENTION:to install the oil cooler Plug & Play, aForge intercooleris required. The oil cooler is then mounted on this. Otherwise, e. g. holes must be drilled in the impact beam. ATTENTION:Noise may be generated after the kit has been installed, but this is harmless. The noise is similar to a "whirring", which can be caused by the pulsation of the oil through the lines. This whirring can be minimised or even eliminated by using silent blocks and decoupling the components.The cooler should be installed as low as possible, otherwise oil pressure problems may occur in exceptional cases! Noise may be generated after the kit has been installed, but this is harmless. The noise is similar to a "whirring", which can be caused by the pulsation of the oil through the lines. This whirring can be minimised or even eliminated by using silent blocks and decoupling the components. The cooler should be installed as low as possible, otherwise oil pressure problems may occur in exceptional cases! Picture similar (picture shows our 19 row cooler. Setrab Pro Line cooler is supplied)